P1635

DTC P1635 Reference Voltage #1 Circuit Fault




Circuit Description
The TP sensor #1 shares a 5 Volt reference with the PCM.

If the PCM detects the 5 Volt reference for the TP sensor #1 is failure, DTC P1635 will be set.

Conditions for Setting the DTC
- The ignition is "ON".
- The 5 Volt reference voltage for the TP sensor # 1 is less than 4 volts.
- The 5 Volt reference voltage for the TP sensor # 1 is more than 5 volts.

Action Taken When the DTC Sets
- The PCM will not illuminate the malfunction indicator lamp (MIL).
- The PCM will store conditions which were present when the DTC was set as Failure Records only. This information will not be stored as Freeze Frame data.

Conditions for Clearing the MIL/DTC
- The PCM will turn the MIL "OFF" on the third consecutive trip cycle during which the diagnostic has been run and the fault condition is no longer present.
- A history DTC P1635 will clear after 40 consecutive trip cycle during which the warm up cycles have occurred without a fault.
- DTC P1835 can be cleared using the Tech 2 "Clear Info" function or by disconnecting the PCM battery feed. Tech 2 "Clear Info" function or by disconnecting the PCM battery feed.

Steps 1 - 6:

Test Description