Sunroof / Moonroof Panel: Adjustments

Sunroof Window Height and Opening Fit Adjustment




1. In order to adjust the glass height, the sunroof glass must be in the zero, closed, position.

Note: Do not remove the screws from the sunroof mechanism.

2. Loosen the 4 adjustment screws.

Caution: Refer to Fastener Caution (Fastener Caution).

3. Adjust the rear glass panel (1) so that it is flush with the roof panel (3), 0-2.0 mm (0.079 in) above 3.

Tighten all 4 adjustment screws to 4 Nm (35 lb in).

4. Adjust the front glass panel (2) so that it is flush with the roof panel (3), 0-1.0 mm (0.040 in) below 3.

Tighten all 4 adjustment screws to 4 Nm (35 lb in).