Power Brake Booster Outlet Front Pipe Replacement

Power Brake Booster Outlet Front Pipe Replacement

Tools Required

CH-47830 Holding Fixture

Caution: Refer to Brake Fluid Irritant Caution (Brake Fluid Irritant Caution) .


Removal Procedure





1. Remove the brake master cylinder and power brake booster assembly. Refer to Brake Master Cylinder with Power Brake Booster and Chassis Control Module Replacement (Brake Master Cylinder with Power Brake Booster and Chassis Control Module Replacement) .
2. Install the CH-47830 (1) to the master cylinder assembly.
3. Position the CH-47830 with the master cylinder assembly in a vise.




4. Disconnect the brake pipe fittings and remove the power brake booster outlet front pipe (1).



Installation Procedure


Notice: Refer to Fastener Notice (Fastener Notice) .





1. Install the power brake booster outlet front pipe (1) and connect the brake pipe fittings.

Tighten the fittings to 15 N.m (11 lb ft).





2. Remove the CH-47830 (1) from the master cylinder assembly.
3. Remove the brake master cylinder and power brake booster assembly. Refer to Brake Master Cylinder with Power Brake Booster and Chassis Control Module Replacement (Brake Master Cylinder with Power Brake Booster and Chassis Control Module Replacement) .