Valve Stem-to-Guide Clearance Inspection (PZEV Models)

Valve Stem-to-Guide Clearance Inspection

1. Remove the valves Valve, Spring, and Valve Seal Removal (PZEV Models).

2. Subtract the O.D. of the valve stem, measured with a micrometer, from the I.D. of the valve guide, measured with an inside micrometer or a ball gauge. Take the measurements in three places along the valve stem and three places inside the valve guide. The difference between the largest guide measurement and the smallest stem measurement should not exceed the service limit.

Intake Valve Stem-to-Guide Clearance





Exhaust Valve Stem-to-Guide Clearance