LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2009 >> S2000 L4-2.2L >> Repair and Diagnosis >> Engine, Cooling and Exhaust >> Engine >> Camshaft, Lifters and Push Rods >> Camshaft >> Service and Repair >> Camshaft Gear Installation

Camshaft Gear Installation




Camshaft Gear Installation

1. Install the camshaft gear (A).
NOTE: The exhaust camshaft gear has a groove (B) in the face. The intake camshaft gear does not have a groove. Be sure to install the correct camshaft gear on each camshafts.

2. Apply new engine oil to the threads of the camshaft gear mounting nut (C), then install it.






3. Hold the camshaft with an open-end wrench, then tighten the camshaft gear mounting nut.

Specified Torque:
118 N-m (12.0 kgf-m, 86.8 lbf-ft)





scientia non olet · About LEMON Manuals