Dashboard Center Upper Panel Removal/Installation

Dashboard Center Upper Panel Removal/Installation

Special Tools Required

- KTC Trim Tool Set SOJATP2014
*Available through the Honda Tool and Equipment Program, 888-424-6857

NOTE:

- Take care not to scratch the dashboard or the related parts.
- Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.

1. Grasp the middle of the center upper panel (A), and pull the panel towards the rear of the vehicle to detach all of the clips from the dashboard (B). Disconnect the center speaker connector (C) (for some models), then remove the center upper panel.





2. Install the cover in the reverse order of removal, and note these items:

- Make sure the center speaker connector is plugged in properly.
- If the clips are damaged or stress-whitened, replace them with new ones.
- Push the clips into place securely.