Front Seat Linkage Disassembly/Reassembly - Driver's 10-Way Power

Front Seat Linkage Disassembly/Reassembly - Driver's 10-Way Power

- The operation of the driver's seat position sensor must be checked after any of these actions Driver's Seat Position Sensor Operation Check.
- Driver's seat position sensor replacement
- Cover plate (front side of driver's seat slide rail) replacement

NOTE:

- Put on gloves to protect your hands.
- To remove the slide motor and the slide gearbox, slide the front seat forward fully.
- Before installing the slide motor and slide gearbox, align portion (A) as shown to align both slide gearbox positions.
- Apply multipurpose grease to the sliding and pivot portions.
- Check operation of the recline adjuster and slide/up-down adjuster.