Wheel Speed Sensor: Service and Repair

Wheel Speed Sensor Replacement

Front

1. Turn the ignition switch to LOCK (0).

2. Remove the front wheel.

3. Remove the bracket (A), then disconnect the wheel speed sensor connector (B).





4. Release the clamps, then remove the bolts, and the wheel speed sensor (C).

5. Install the wheel speed sensor in the reverse order of removal, and note these items:

- Do not twist the sensor wires.
- If the wheel speed sensor comes in contact with the wheel bearing, it is faulty.
- Make sure there is no debris in the sensor mounting hole.

Rear

1. Turn the ignition switch to LOCK (0).

2. Remove the rear wheel.

3. Disconnect the wheel speed sensor connector (A).





4. Release from the clamps, then remove the clips, the bolt, and the wheel speed sensor (B).

5. Install the wheel speed sensor in the reverse order of removal, and note these items:

- Do not twist the sensor wires.
- If the wheel speed sensor comes in contact with the wheel bearing unit, it is faulty.
- Make sure there is no debris in the sensor mounting hole.