Intermediate Shaft Installation

Intermediate Shaft Installation

1. Install a new set ring (A).

2. Clean the areas where the intermediate shaft contacts the differential thoroughly with solvent or brake cleaner, and dry with compressed air.
NOTE: Do not wash the rubber parts with solvent.






3. Insert the intermediate shaft (A) into the differential correctly.
NOTE: Insert the intermediate shaft carefully to prevent damaging the oil seal (B).






4. Install the flange bolt (A) and the two dowel bolts (B).






5. Install the heat cover (A).

6. Install the right driveshaft. Front Driveshaft Installation

7. Refill the transmission with the recommended transmission fluid:
- Manual transmission MTF Inspection and Replacement

- Automatic transmission ATF Replacement

8. Check the wheel alignment, and adjust it if necessary. Service and Repair

9. Test-drive the vehicle.