Interior Trim Removal/Installation - Cargo Area

Interior Trim Removal/Installation - Cargo Area

Special Tools Required

- KTC trim tool set SOJATP2014*
NOTE:

- Put on gloves to protect your hands.

- Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.

- Take care not to bend or scratch the trim or the panels.

1. Remove the cargo area trim as shown. To remove the rear trim panel, lift up on the hinged section and hold it, then remove the screws and release the clips.

2. Install the trim in the reverse order of removal, and note these items:
- If the clips are damaged or stress-whitened, replace them with new ones.

- Push the clips into place securely.