DTC 83

DTC 83: No VSP Signal

NOTE: If DTC 85 is also set, troubleshoot DTC 85 first.

1. Turn the ignition switch ON (II).
2. Clear the DTC with the HDS.
3. Test-drive the vehicle at 7 mph (10 km/h) or more.
4. Check the speedometer.
Does the speedometer register speed?
YES - Go to step 5.
NO - Substitute a known-good ECM/PCM, and retest. If no codes are shown, replace the original ECM/PCM.

5. Check the Vehicle Speed in the TPMS DATA LIST with the HDS.
Is the vehicle speed indicated?
YES - The system is OK at this time.
NO - Substitute a known-good TPMS control unit, and recheck.