Range Selector Lever Cable Bracket Replacement

Range Selector Lever Cable Bracket Replacement

Removal Procedure

1. Set the park brake and chock the wheels.




2. Disconnect the range selector cable end (1) from the range selector lever.
3. Disconnect the range selector cable (2) from the range selector cable bracket.




4. Remove the transmission range selector cable bracket bolts (1).
5. Remove the transmission range selector cable bracket (2).

Installation Procedure




1. Install the transmission range selector cable bracket (2).

Caution: Refer to Fastener Caution (Fastener Caution).

2. Install the transmission range selector cable bracket bolts (1) and tighten to 25 Nm (18 lb ft).




3. Connect the range selector cable (2) to the range selector cable bracket.
4. Connect the range selector cable end (1) to the range selector lever.
5. Check the range selector cable adjustment. Refer to Range Selector Lever Cable Adjustment (6T30/6T40/6T45/6T50 - Automatic Transmission).