Parking Assist Distance Sensor: Service and Repair

Parking Aid Sensor









Removal and Installation

1. Remove the rear bumper cover. For additional information, refer to Bumpers Service and Repair.

2. Disconnect the parking aid sensor(s) electrical connector(s).

3. Pry the retaining tabs with a suitable tool, such as a flat bladed screwdriver and remove the parking aid sensor(s).

4. To install, reverse the removal procedure.
- Carry out the azimuth and elevation system check. For additional information, refer to Azimuth System Check Azimuth System Check and Elevation System Check Elevation System Check.