LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2011 >> Focus L4-2.0L >> Repair and Diagnosis >> Engine, Cooling and Exhaust >> Engine >> Drive Belts, Mounts, Brackets and Accessories >> Engine Mount >> Service and Repair >> Removal and Replacement

Removal and Replacement




Engine Mount





Coolant Expansion Tank









Engine Mount









Removal and Installation

1. Remove the 2 expansion tank bolts.
- To install, tighten to 4 Nm (35 lb-in).

2. Lift the coolant expansion tank off of the engine mount stud bolt and position it aside.

3. Install the Engine Support Bar.





4. Remove the 2 engine mount nuts.
- To install, tighten to 90 Nm (66 lb-ft).

5. Remove the 2 bolts, stud bolt and the engine mount.
- To install, tighten to 48 Nm (35 lb-ft).

6. To install, reverse the removal procedure.

scientia non olet · About LEMON Manuals