Hood Latch: Service and Repair

Hood Latch

NOTE: Expedition shown, Navigator similar.









Removal and Installation

1. Remove the 10 pin-type retainers and the upper radiator sight shield.

2. Remove the 2 bolts and the hood latch.
- To install, tighten to 35 Nm (26 lb-ft).


3. Release the hood latch cable from the hood latch.





4. To install, reverse the removal procedure.
- Verify the hood latch engages the striker in the latched position (secondary).

- Verify the hood latch engages the striker in the fully latched position (primary).

- Adjust the hood latch as necessary.