Steering Angle Sensor: Service and Repair

Steering Wheel Rotation Sensor


















Removal and Installation

1. Remove the steering column opening cover.

2. Remove the 2 bolts and detach the data link harness retainer.





3. Remove the 4 bolts and the instrument panel LH knee bolster.
- To install, tighten bolts to 9 Nm (80 lb-in).


4. Disconnect the steering wheel rotation sensor electrical connector.

5. Remove the 2 steering wheel rotation sensor bolts.
- To install, tighten to 1 Nm (9 lb-in).


6. Remove the steering wheel rotation sensor.

7. To install, reverse the removal procedure.
- For vehicles equipped with Roll Stability Control (RSC(R)), carry out the IVD Initialization sequence. Follow the scan tool directions.