Instrument Panel Finish Panel - RH

Instrument Panel Finish Panel - RH

Removal and Installation

1. NOTE: The ignition switch must be in the OFF position for at least 1 minute if disconnecting the Passenger Air Bag Deactivation (PAD) indicator electrical connector. Otherwise, a DTC will be set in the Restraints Control Module (RCM) memory and must be cleared before releasing the vehicle.

Position the ignition switch to the OFF position.

2. NOTICE: When prying on a component, a non-marring tool must be used or damage to the component may occur.

Remove the RH instrument panel finish panel.

- Starting at the RH side of the RH instrument panel finish panel, use a non-marring tool to pry the RH instrument panel finish panel outward to release the retaining clips.
- Disconnect the electrical connectors.





3. To install, reverse the removal procedure.
- Make sure to align the retaining clips to the adjacent retaining clip holes.