Trunk / Liftgate Shock / Support: Service and Repair

Power Liftgate Rod













Removal and Installation

1. Remove the LH quarter trim panel access cover.





2. Unclip the power liftgate rod from the motor assembly.
- Squeeze the clip as shown to release and position the rod assembly upward.





3. Remove the cover and the power liftgate rod-to-liftgate nut.
- To install, apply threadlock to the threads of the fastener and tighten to 9 Nm (80 lb-in).

4. Remove the 3 power liftgate rod mounting bracket nuts.
- To install, tighten to 9 Nm (80 lb-in).

5. To install, reverse the removal procedure.
- Initialize the power liftgate. For additional information, refer to Power Liftgate Initialization Procedures.