Transmission Support Insulator - Anti Roll

Transmission Support Insulator - Anti Roll AWD

Material(s)






Exploded View











Removal

1. With the vehicle in NEUTRAL, position it on a hoist. REFER to Lifting Points Service and Repair.

2. Remove the 2 roll restrictor bracket bolts and the through bolt and remove the rear roll restrictor.





Installation

1. Clean the roll restrictor bolts using a wire brush and apply new Threadlock and Sealer to the threads.

2. NOTE: The bracket has keyed tabs to orientate the roll restrictor.

Position the roll restrictor bracket and the rear roll restrictor in place, align the keyed tabs and install the bolts.

- Tighten to 90 Nm (66 lb-ft).