Antenna Cable: Service and Repair

Antenna Cable - AM/FM/Satellite Radio

Antenna Cable-to-Antenna










Upper Antenna Cable-to-Lower Antenna Cable










Lower Antenna Cable









Removal and Installation

Lower antenna cable

1. Remove the Audio Front Control Module (ACM). For additional information, refer to Audio Control Module (ACM) Audio Control Module (ACM).

Upper antenna cable

2. Remove the RH A-pillar trim panel.

3. Remove the front interior lamp.

4. Loosen the AM/FM antenna base bolt and disconnect the antenna cable from the antenna.
- To install, tighten to 7 Nm (62 lb-in).


5. Remove the RH sun visor.

6. NOTE: Lower the headliner, as necessary.
Remove the AM/FM antenna cable bolt and the antenna cable.

- To install, tighten the bolt to 12 Nm (106 lb-in).


Both antenna cables

7. Remove the RH front door scuff plate.

8. Disconnect the upper antenna cable from the lower antenna cable.

9. Release the pin-type retainers and remove the antenna cable.

10. To install, reverse the removal procedure.