Power Running Board (PRB) Gap Hider

Power Running Board (PRB) Gap Hider

NOTE: RH shown, LH similar.











1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Vehicle Jacking and Lifting.

2. NOTE: If the Power Running Board (PRB) cannot be extracted, extend the running board by hand.

Extend the PRB.

3. Remove the 2 pushpins and 2 scrivets.

4. Remove the 3 gap hider-to-bracket screws.

5. Remove the PRB gap hider.

6. To install, reverse the removal procedure.