Oil Pump Pick-up - Installation

INSTALLATION





1. Lightly lubricate the new O-ring seal (1) with engine oil and install on the oil pump.





2. Install the oil pick-up tube (1) with two bolts (2). Tighten the bolts to 10 Nm (89 in. lbs.).
3. Install the oil pan Engine Oil Pan - Installation.
4. If removed, install the oil filter and fill the engine crankcase with the proper oil to the correct level Service and Repair.
5. Connect the negative battery cable and tighten nut to 5 Nm (45 in. lbs.).
6. Run the engine until it reaches normal operating temperature.