Installation

INSTALLATION





1. Position the fuel filler tube into the vehicle.
2. Insert the fuel filler tube hose into the fuel tank filler neck.





3. Slide the fuel filler tube hose clamp into position and tighten.





4. Install the fuel filler tube retaining nut (5) and tighten to 12 Nm (9 ft. lbs.).
5. Reconnect the fuel filler tube ORVR line (3).

6. Partially lower vehicle.




7. Install the fuel filler housing to the fender.
8. Align the fuel filler tube to the fuel filler housing rubber seal and press the housing into place.
9. Press the housing till it locks into place.





10. Connect the fuel door release solenoid electrical connector (5).





11. Position the rear wheelhouse splash shield (2) to the body and install the push-pins (1).
12. Install the left rear tire.
13. Lower the vehicle.





14. Connect the negative battery cable (1).
15. Fill the fuel tank and check for leaks.