Crankshaft Rear Oil Seal Retainer - Removal

REMOVAL






NOTE: The crankshaft rear oil seal is integral to the crankshaft rear oil seal retainer and must be replaced as an assembly.

NOTE: The crankshaft rear oil seal retainer can not be reused after removal.

NOTE: This procedure can be performed in vehicle.

1. Disconnect the negative battery cable.
2. Remove the transmission.
3. Remove the flexplate Flexplate - Removal
4. Remove the oil pan Engine Oil Pan - Removal
5. Using the sequence shown, remove the rear oil seal retainer mounting bolts.
6. Carefully remove the retainer from the engine block.