DTCM Verification Test

STANDARD PROCEDURE - DTCM VERIFICATION TEST
DTCM VERIFICATION TEST
1. Disconnect all jumper wires and reconnect all previously disconnected components and connectors.
2. With the scan tool, erase DTCs.
3. Make sure that all accessories are turned off and that the battery is fully charged.
4. Test drive the vehicle and verify proper operation.
5. With the scan tool, read DTCs in the DTCM.

Are there any DTCs present in the Drive Train Control Module (DTCM)?

Yes

- Testing and Inspection Perform the appropriate diagnostic procedure.

No

- Repair is complete.