Vibration Damper - Removal

REMOVAL





1. Disconnect negative cable from battery.
2. Remove accessory drive belt Serpentine Accessory Drive Belt - Removal.
3. Drain cooling system Service and Repair.
4. Remove radiator upper hose.
5. Remove upper fan shroud.
6. Using Spanner Wrench 6958 with Adapter Pins 8346 (1), loosen fan and viscous assembly from water pump.
7. Remove fan and viscous assembly.
8. Disconnect electrical connector for fan mounted inside radiator shroud.






NOTE: Transmission cooler line snaps into shroud lower right hand corner.

9. Remove vibration damper bolt.
10. Remove damper using Special Tools 8513A Insert and 1023 Three Jaw Puller (2).