Brake and/or Accelerator Pedals - Description

DESCRIPTION

STANDARD PEDALS





NOTE: The brake pedal is serviced as a complete assembly including the bracket.

A suspended-type brake pedal (5) is used. The pedal is attached to the pedal support bracket (4) with a pivot shaft pin (2), bushings (3) and clips (1). If the bushings (3) become dry a spray lubricant can be used to eliminate noises. The booster push rod is attached to the pedal with a clip. The pedal (5), bushings (3), pivot pin (2) and support bracket (4) are not serviceable components.

ADJUSTABLE PEDALS - WITHOUT 5.7L HEV





NOTE: The non HEV adjustable pedal assembly can be serviced in 5 sub components as listed below.

NOTE: When replacing the components both pedal assemblies must be in the fully down position toward the floor for proper adjustment. Pedals can be moved manually by rotating the cable on the component not being replaced. New components come in the correct position until activated.

The adjustable brake pedal assembly is similar to the standard brake pedal assembly with additional components necessary for pedal adjustment. Sub components may be replaced separately. Replaceable sub components are as follows:

- Accelerator pedal (5)
- Bracket housing (2)
- Brake pedal assembly (1)
- Drive cable (between motor and brake pedal) (3)
- Motor (4)

ADJUSTABLE PEDALS - 5.7L HEV





NOTE: The 5.7L HEV brake pedal assembly is serviced as a complete assembly including the bracket.

The 5.7L HEV brake pedal assembly is similar to the non HEV brake pedal assembly with additional components necessary for the overall operation of the HEV systems. The components are calibrated together and cannot be interchanged or replaced separately. HEV specific components (not serviced separately) are listed below:

- Brake pedal angle sensor (1)
- Brake pedal simulator cut off (3)
- Brake pedal simulator (4)