Seat Belt Turning Loop Adjuster - Installation

INSTALLATION





1. Place seat belt height adjuster (4) into position.
2. Slide the lower hook (2) down into the B-pillar opening (1).
3. Install bolt (3) attaching height adjuster (4) to B-pillar. Tighten bolt to 59 Nm (43.5 ft. lbs.).





4. Install the bolt (3) attaching the turning loop (2) to the height adjuster (1). Tighten bolt to 34 Nm (25 ft. lbs.).
5. Install B-pillar trim panel (4) B-Pillar Trim Panel - Installation.