Instrument Panel Bezel - Removal

REMOVAL

Special Tools:










1. Before proceeding with the following repair procedure, review all warnings and cautions.
2. Disconnect the negative battery cable.
3. Remove the AC/heater control faceplate (2) from the I/P, Instrument Cluster Switch Pod - Removal.





4. Remove and disconnect the telematics gateway assembly (1), Telematics Gateway Module - Removal.





5. Using C-4755 or equivalent, remove the center bezel (1) from the instrument panel by releasing the snap retainers from the instrument panel.





6. Disconnect the harness connectors (2, 3 & 4) from the rear of the display screen (1).
7. Disconnect the clock harness and remove the center trim bezel.