U0001

U0001-CAN C BUS

For a complete wiring diagram, refer to the Wiring Information .

- When Monitored:
Continuously when the ignition is on.

Battery voltage between 10 and 16 volts.

- Set Condition:
The controller detects an open, short to ground, or a short to voltage on the CAN C Bus circuit.





VERIFY DIAGNOSTIC TROUBLE CODE (DTC) IS ACTIVE

NOTE: For vehicle communication problems, use the scan tool to refer to the Network Review Screen. The screen depicts a high level view of the vehicle network. Fault and problem areas appear in red. Selecting any of the network components allows access to the source of the problem.

1. Turn the ignition on.
2. With the scan tool, read active DTCs.

Is this DTC active?

Yes

- U0002 Perform the U0002-CAN C Bus Off Performance diagnostic procedure.

No

- Stored Lost Communication DTCs Perform the Stored Lost Communication DTCs diagnostic procedure.