Installation

INSTALLATION





1. Ensure that U-nuts (1) are in position in the roof bow (2).




2. Raise sunroof module assembly and guide it carefully into position.
3. While supporting the sunroof assembly, start the attaching screws. Tighten the attaching screws in sequence to 6 Nm (53 in. lbs.) torque.




4. Connect sunroof wire connector.
5. Connect the drain tubes to the sunroof. Installation.
6. Connect battery negative cable.
7. Test sunroof operation, adjust the position of the glass panel as necessaryAdjustments.
8. Install headliner. Headliner - Installation.