Power Brake Booster - Removal

LHD BRAKE BOOSTER





1. Remove the master cylinder. Master Cylinder - Removal.
2. Disconnect the vacuum hose (1) at the booster check valve (2).




3. Remove the brake rod pin retaining clip (4) that holds the boosters push rod (1) to the pedal (3). Then slide the push rod off the pin (2).




4. Remove the booster retaining nuts (2) and the gasket (3) that attach the booster (1) to the dash panel.
5. Slide booster forward, tilt the booster upward slightly, then remove the booster from the engine compartment.