Instrument Panel Bezel - Installation

INSTALLATION





1. If removed, install the instrument panel air outlets onto the back of the center bezel Air Outlet - Installation.
2. If removed, install the power window switches onto the back of the center bezel Power Window Switch - Installation.
3. If removed, install the clock onto the back of the center bezel Clock - Installation.
4. If removed, install the A/C-heater control and the accessory switch bezel onto the back of the center bezel. Install and tighten the retaining screws to 2 Nm (17 in. lbs.).
5. Position the center bezel (1) to the instrument panel (2) and connect the control cables and wire harness connectors to the back of the A/C-heater control A/C and Heater Control - Installation.
6. Connect the wire harness connectors to the accessory switches, clock and power window switches (as equipped).
7. Install the center bezel onto the instrument panel. Make sure the snap retainers are fully engaged to the instrument panel.
8. Install center bezel attaching screws (3) located inside each vents.
9. Reconnect the negative battery cable.