Air Cleaner Fresh Air Duct/Hose: Service and Repair

Air Cleaner Outlet Duct Replacement

Removal Procedure




1. Remove the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement Fuel Injector Sight Shield Replacement.

2. Disconnect the PCV quick disconnect (2). Refer to Plastic Collar Quick Connect Fitting Service Service and Repair.




3. Loosen the air cleaner outlet duct clamps (1) at the mass air flow (MAF)/intake air temperature (IAT) sensor and throttle body.

4. Remove the air cleaner outlet duct.

Installation Procedure




1. Loosely Install the air cleaner outlet duct then install the fuel injector sight shield to ensure proper clearance.

2. Remove the fuel injector sight shield.

Caution: Refer to Fastener Caution Fastener Caution.

3. Tighten the air cleaner outlet duct clamps (1) to 4 Nm (35 lb in)at the MAF/IAT sensor and throttle body.




4. Connect the PCV quick disconnect (2). Refer to Plastic Collar Quick Connect Fitting Service Service and Repair.

5. Install the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement Fuel Injector Sight Shield Replacement.