Transmission Control Lever Boot Replacement

Transmission Control Lever Boot Replacement

Removal Procedure

1. Remove the transmission control lever. Refer to Transmission Control Lever Knob Replacement Transmission Control Lever Knob Replacement.





2. Lift and push the lower edge of the control lever boot as necessary in order to expose the retaining screws

3. Remove the 4 control lever boot retaining screws (2).

4. Carefully release the 4 plastic retainers (3) from the floor and remove the control lever boot retaining bezel (1), boot (4), and retainers (3) as an assembly.

5. Remove the 4 plastic retainers (3) in order to separate the control lever boot retaining bezel (1) from the boot (4).

6. Remove the control lever insulator (5) from the floor.

Installation Procedure





1. Install the control lever insulator (5) to the floor.

2. Assemble the control lever boot retaining bezel (1) to the boot (4) and insert the 4 plastic retainers (3).

3. Install the control lever boot retaining bezel (1), boot (4) and secure the 4 plastic retainers (3) to the floor.

Caution:
Refer to Fastener Caution Fastener Caution.

4. Lift and push the lower edge of the control lever boot as necessary in order to install the 4 retaining screws (2).

Tighten the screws to 1.6 Nm (14 lb in).

5. Install the transmission control lever. Refer to Transmission Control Lever Knob Replacement Transmission Control Lever Knob Replacement.