Drive Belt Tensioner: Service and Repair

Drive Belt Tensioner Replacement

Removal Procedure





1. Remove the drive belt. Refer to Drive Belt Replacement Service and Repair.

2. Remove the belt tensioner bolt.

3. Remove the belt tensioner.

Ensure that there is a locating pin (1) on the tensioner.

Installation Procedure





1. Install the belt tensioner. Position the locating pin (1) on the tensioner into the hole in the generator bracket.

Caution:
Refer to Fastener Caution Fastener Caution.

2. Install the belt tensioner bolt and tighten to 50 Nm (37 lb ft).

3. Install the drive belt. Refer to Drive Belt Replacement Service and Repair.