Evaporative Emission Canister Replacement (Cutaway Van)

Evaporative Emission Canister Replacement (Cutaway Van)

Removal Procedure





1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle Service and Repair.

2. Disconnect the vent hose from the canister.

3. Disconnect the chassis EVAP purge pipe from the EVAP canister.

4. Disconnect the fuel tank EVAP pipe from the canister.

5. Remove the EVAP canister from the EVAP Canister bracket.

Installation Procedure





1. Connect the fuel tank EVAP pipe to the canister.

2. Connect the chassis EVAP purge pipe to the EVAP canister.

3. Connect the vent hose to the canister.

4. Install the EVAP canister to the EVAP Canister bracket.

Caution:
Refer to Fastener Caution Fastener Caution.

5. Install the EVAP canister bracket bolt and tighten to 12 Nm (106 lb in).

6. Lower the vehicle.