Getrag 5 Speed - Manual Transmission

Backup Lamp Switch Replacement

Removal Procedure

Caution: When removing or installing the backup lamp switch, do not use an open end wrench. Use only a socket in order to avoid damage to the switch assembly.

1. Remove the left front wheel. Refer to Tire and Wheel Removal and Installation (Service and Repair).
2. Disconnect the backup lamp connector (1).




3. Remove the backup lamp switch assembly.

Installation Procedure

Caution: When removing or installing the backup lamp switch, do not use an open end wrench. Use only a socket in order to avoid damage to the switch assembly.





Caution: Refer to Fastener Caution (Fastener Caution).

1. Install the backup lamp switch using pipe sealant.

Tighten the switch to 33 Nm (24 lb ft).

2. Connect the backup lamp connector (1).
3. Install the left front wheel. Refer to Tire and Wheel Removal and Installation (Service and Repair).