Rear Speaker Do Not Mute When Radio Is On

Diagnostic Trouble Code Chart:

Wiring Schematics:

CIRCUIT DESCRIPTION
The Video Entertainment System (VES) controls the operation of the rear speakers. The Auxiliary Video Module (AVM) has an audio amplifier which is used to sound video audio through the rear speakers. The Interface Module (IM) senses when the radio is in use through CKT 145. When the radio is oft, the IM allows the rear speakers to sound video audio. However, when the radio is turned on, the IM mutes the rear speakers; video audio is then available through the headphone jacks at the second or third seat audio controls only. This action prevents two sources of audio to be heard at the same time (radio audio through the front speakers and video audio through the rear speakers.)

DIAGNOSTIC AIDS
^ Check for the following conditions:
- An open in CKT 145 between the radio and the AVM
- An open in CKT 145 between the AVM and the IM
- An open in CKT 150 between the IM and the AVM
- A faulty radio
- A faulty IM
^ An intermittent failure may be very difficult to detect and to diagnose accurately. Faulty electrical connections or wiring causes most intermittent problems. When an intermittent condition is suspected, check the suspected circuits for the following conditions:
- Poor mating of connector halves or backed out terminals
- Improperly formed or damaged terminals
- Wire chafing
- Poor wire to terminal connections
- Dirty or corroded terminals
- Damage to connector bodies
- Wire broken inside the insulation

TEST DESCRIPTION
The number(s) below refer to the step number(s) on the diagnostic table.
1. Determines whether the malfunction is at the radio, or at the AVM or IM.
2. Determines whether the IM or AVM is faulty.
3. for an open in CKT 150.
5. Tests if CKT 145 is open between the radio and the AVM, or that the radio is not sending voltage signal when radio is on.
10. Verifies repairs made to the VES.