F13-5/F15-5/F17-5 - Manual Transmission

Backup Lamp Switch Replacement

Removal Procedure





1. Disconnect the electrical connector from the backup lamp switch (1).

2. Remove the backup lamp switch (1) from the transmission.

3. Remove and DISCARD the backup lamp switch washer from the backup lamp switch.

Installation Procedure





1. Install a NEW backup lamp switch washer on the backup lamp switch (1).

Caution:
Refer to Component Fastener Tightening Caution Component Fastener Tightening Caution.

2. Install the backup lamp switch (1) into the transmission case, and tighten to 20 Nm (15 lb ft).

3. Connect the electrical connector to the backup lamp switch (1).