Lifter / Lash Adjuster: Service and Repair

Valve Lifter Replacement

Special Tools

EN-845 - Suction Device

For equivalent regional tools, refer to Special Tools Special Tools.

Removal Procedure

1. Remove the camshaft. Refer to Camshaft Replacement Camshaft Replacement.





Note:
Mark the assignments.

2. Remove the valve lifter (1) use the EN-845 - suction device.

Installation Procedure





Note:
Observe the correct assignment.

Note:
Coat the sliding surfaces with NEW engine oil.

1. Install the valve lifter (1) use the EN-845 - suction device.

2. Install the camshaft. Refer to Camshaft Replacement Camshaft Replacement.