LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Corvette V8-7.0L >> Repair and Diagnosis >> Engine, Cooling and Exhaust >> Engine >> Drive Belts, Mounts, Brackets and Accessories >> Idler Pulley >> Service and Repair

Idler Pulley: Service and Repair




Drive Belt Idler Pulley Replacement (w/o LS9)

Removal Procedure





1. Remove the accessory drive belt. Refer to Drive Belt Replacement - Accessory (LS9) Drive Belt Replacement - AccessoryDrive Belt Replacement - Accessory (w/o LS9) Drive Belt Replacement - Accessory.

2. Loosen the drive belt idler pulley mounting bolt.

3. Remove the drive belt idler pulley.

Installation Procedure





1. Position the drive belt idler pulley on generator mounting bracket.

2. Hand tighten the drive belt idler pulley mounting bolt.

Caution:
Refer to Fastener Caution Fastener Caution.

3. Tighten the drive belt idler pulley bolt.

Tighten the drive belt idler pulley bolt to 50 Nm (37 lb ft).

4. Install the accessory drive belt. Refer to Drive Belt Replacement - Accessory (LS9) Drive Belt Replacement - AccessoryDrive Belt Replacement - Accessory (w/o LS9) Drive Belt Replacement - Accessory.

scientia non olet · About LEMON Manuals