64. Oil Pan Cleaning and Inspection

Oil Pan Cleaning and Inspection (6.2L LS3)





1. Remove the oil filter fitting (1), as required.





2. Clean the oil pan in solvent.

Warning:
Refer to Safety Glasses Warning Safety Glasses Warning.


3. Dry the oil pan with compressed air.

4. Inspect the oil pan for the following conditions:

* Damaged gasket surfaces (1)

* Restrictions within the oil passages (2) of the pan

* Damaged oil filter seal surface (3)

* Threaded bolt holes (4) for damage





Caution:
Refer to Fastener Caution Fastener Caution.

5. Install the oil filter fitting (1), as required, and tighten to 55 Nm (40 lb ft).