Transmission Mount Bracket Replacement - Rear

Transmission Mount Bracket Replacement - Rear

Removal Procedure

1. Raise vehicle. Refer to Lifting and Jacking the Vehicle (Service and Repair).
2. Support rear of powertrain using a suitable jack stand.




3. Remove transmission rear mount bolt (1).




4. Remove 3 transmission rear mount bolts (1).
5. Remove transmission rear mount (2).

Installation Procedure




1. Install transmission rear mount (2).

Caution: Refer to Fastener Caution (Fastener Caution).

2. Install 3 transmission rear mount bolts (1) and tighten to 100 Nm (74 lb ft).




3. Install transmission rear mount bolt (1) and tighten to 100 Nm (74 lb ft).
4. Remove jack stand.
5. Lower vehicle.