Drive Belt Tensioner: Service and Repair

Drive Belt Tensioner Replacement

Removal Procedure

1. Open the hood.
2. Remove the generator and air conditioning compressor belt. Refer to Drive Belt Replacement (Service and Repair).




3. Remove the drive belt tensioner bolt (2).
4. Remove the drive belt tensioner (1).

Installation Procedure

1. Clean the drive belt tensioner thread.




2. Install drive belt tensioner (1).

Caution: Refer to Fastener Caution (Fastener Caution).

3. Install drive belt tensioner bolt (2) and tighten to 55 Nm (41 lb ft).
4. Install the generator and air conditioning compressor belt. Refer to Drive Belt Replacement (Service and Repair).
5. Close the hood.