Idler Pulley: Service and Repair

Drive Belt Idler Pulley Replacement

Removal Procedure




1. Remove the accessory drive belt. Refer to Drive Belt Replacement - Accessory (Service and Repair).
2. Loosen the necessary drive belt idler pulley bolt.
3. Remove the necessary drive belt idler pulley.

Installation Procedure




1. Position the necessary drive belt idler pulley to the coolant manifold and/or generator bracket.

Caution: Refer to Fastener Caution (Fastener Caution).

2. Tighten the necessary drive belt idler pulley bolt.

Tighten the bolt to 50 Nm (37 lb ft).

3. Install the drive belt. Refer to Drive Belt Replacement - Accessory (Service and Repair).