LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2008 >> Impala V8-5.3L >> Repair and Diagnosis >> Transmission and Drivetrain >> Transmission Control Systems >> Actuators and Solenoids - Transmission and Drivetrain >> Actuators and Solenoids - A/T >> Shift Interlock Solenoid >> Service and Repair

Shift Interlock Solenoid: Service and Repair



Automatic Transmission Shift Lock Actuator Replacement

Removal Procedure





1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (RPO LS4) Battery Negative Cable Disconnection and Connection (RPOs LZE/LZ4/LZ8) .

Notice: To prevent component damage, DO NOT use metal tools to remove the trim.


Important: Use only a plastic trim tool to lift the shift lever bezel or trim plate. Do not use any tool between the shift lever bezel or trim plate and the shifter.


2. Remove the center console. Refer to Front Floor Console Replacement (Impala) .
3. Disconnect the automatic transaxle shift lock actuator electrical connector (1).
4. Remove both ends of the automatic transaxle shift lock actuator from the pivot points.



Installation Procedure





1. Install both ends of the automatic transaxle shift lock actuator to the pivot points.
2. Connect the automatic transaxle shift lock actuator electrical connector (1).
3. Install the center console. Refer to Front Floor Console Replacement (Impala) .
4. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (RPO LS4) Battery Negative Cable Disconnection and Connection (RPOs LZE/LZ4/LZ8) .


scientia non olet · About LEMON Manuals