Rear Seat Back Cushion Replacement (Non Folding)

Rear Seat Back Cushion Replacement (Non Folding)

Removal Procedure




1. Remove the rear seat cushion. Refer to Rear Seat Cushion Replacement (Rear Seat Cushion Replacement).
2. Remove the nuts from the rear seat retainer at the bottom of the rear seat back.




3. Grasp the bottom of the rear seat back and lift upward to disengage offsets on the upper frame bar from the hangers.
Lift the rear seat back upwards to remove from the rear shelf.
4. Remove the rear seat back from the vehicle.

Installation Procedure




1. Position the rear seat back to the vehicle.
2. Hook the seat back upper frame to the hangers on the rear shelf.





Notice: Refer to Fastener Notice in Cautions and Notices.

3. Install the rear seat back nuts.

Tighten the rear seat back nuts to 10 Nm (89 lb in).

4. Install the rear seat cushion. Refer to Rear Seat Cushion Replacement (Rear Seat Cushion Replacement).