Rear Bumper Shock Absorber: Service and Repair

Rear Energy Absorber Replacement (Impala)

Tools Required

J 38778 Door Trim Pad Clip Remover

Removal Procedure




1. Remove the rear bumper fascia. Refer to Rear Bumper Fascia Replacement (Impala) (Service and Repair).
2. Remove the push-in retainers from the rear bumper energy absorber using J 38778 .
3. Remove the rear bumper energy absorber from the rear bumper impact bar.

Installation Procedure




1. Position the rear bumper energy absorber to the rear bumper impact bar.
2. Install the push-in retainers to the rear bumper energy absorber.
3. Install the rear bumper fascia. Refer to Rear Bumper Fascia Replacement (Impala) (Service and Repair).