Vapor Vent Pipe Installation

VAPOR VENT PIPE INSTALLATION

IMPORTANT: Install the vapor vent pipe gaskets properly onto the vapor vent pipe.

Position the gasket O-ring seal onto the nipple portion of the pipe.





1. Install the gaskets onto the vapor vent pipe.

IMPORTANT: Route the knock sensor wire harness over the top of the vapor vent pipe. The vapor vent pipe and knock sensor wire harness should be installed in a manner as to allow the removal of the wire harness without requiring the removal of the vapor vent pipe.

2. Install the vapor vent pipe and gaskets onto the cylinder heads.

NOTICE: Refer to Fastener Notice in Service Precautions.

3. Install the vapor vent pipe bolts.
^ Tighten the vapor vent pipe bolts to 12 Nm (106 inch lbs.).





4. Install the vapor vent hose and clamp onto the vapor vent pipe.